Category IV
Used at the origin of
the installation. Examples are utility
transformers, electricity meters, fusing and distribution panels. High transient voltages are very likely.
Category III
Used in fixed
installations and for cases where the reliability and the availability of the
equipment is subject to special requirements.
These installations will have permanent connection to the distribution
panel (hard wired). Wiring impedance,
fuses and circuit breakers somewhat reduce the level of voltage transients.
Category II
This covers energy-consuming
equipment supplied from the fixed installation.
These would be items normally plugged in to a regular wall outlet or
other plug in fixture requiring 115 or 230Vac. The impedance of wiring
circuits further reduces transient voltages to a lower level. Outlets, lighting
switches and building connections more than 10m from a Category III source are
classed at a Category II.
Category I
These are circuits
requiring low voltage, which limit over voltage conditions to the appropriate
level, i.e. protected electronic circuits.
Each category has to withstand a different
level of voltage transient depending upon the nominal input voltage as shown in
Table 1
Table 1: Tolerated transient voltage
The standard IEC 60204-1:2016 governs the safety of machinery. The general requirements apply to electrical, electronic and programmable electronic equipment that are fixed in their location. The equipment covered by this part of the standard commences at the point of connection of the supply to the electrical equipment of the machine.
An
industrial robot, or material forming machine, wired to the distribution panel
would need to comply with Overvoltage Category III, as shown in Figure 1. If
the AC-DC power supply inside of the robot controller was only OVC II, then an
isolating transformer (not necessarily a step down type) would have to be
fitted inside or between the controller and the distribution panel. The impedance of the transformer would be
enough to reduce the transient voltage level.
Figure 1: Levels of Overvoltage Category
inside of a factory or facility
Some
OVC III industrial AC-DC power supplies are available, like TDK-Lambda’s 240W
rated 24V output ZWS240RC-24 power supply.
Although based on TDK-Lambda’s ZWS300BAF-24
which is OVC II, it has increased spacing from the Line and Neutral to ground,
including additional spacing on the input connector. It is also certified to EN 62477-1 - safety
requirements for power electronic converter systems and equipment. It is said to be a more suitable
specification than EN 50178 which covers electronic equipment for use in power
installations.
The use of such a power supply can eliminate
the isolation transformer, saving both cost and space.
